Auto-Selecting Replenishment and Cycle Count Tasks

Use Warehouse Operation Queuing to set the system to automatically select replenish and cycle count tasks.

We recommend that you schedule Warehouse Operation Queuing to run once a day at an off-peak time. If you need to run the function immediately, open the Warehouse Operation Queuing screen to generate the process. When the processing is complete, the phantom sends you a message and the system generates the Blank Locations Report. Use this report to view product and locations that have been selected for replenish or cycle count tasks.

For a description of the report, see What the Report Shows at the end of the topic.

Note: Avoid using Warehouse Operation Queuing too often in a single day as cycle count tasks are selected each time the function is run.

To auto-select replenish and cycle-count tasks:

1. From the Warehouse Management > Warehouse Maintenance menu, select Warehouse Operation Queuing to display the Warehouse Operation Queuing window.

2. In the Branch/Territory/All field, enter the branch or territory to indicate the area where you want to check inventory. Enter ALL to check inventory for all areas.

3. In the Load All Items Ranked field, do one of the following:

• For replenish tasks, leave blank. If you enter a rank in this field, replenish tasks are not selected.

• For cycle counting, select a product rank from the list if you want to select cycle count tasks based on rank.

4. Set options, if needed, and run the program.

What the Report Shows

The Blank Locations Report shows the following information:

See Also:

RF Replenishment Overview

RF Cycle Count Overview

Selecting RF Daily Replenish Tasks to Pick

Performing RF Daily Replenish Tasks